Søkeresultat for: “
power station til salgs
”
Andre har kjøpt det du leter etter
Sammenligne med tidligere solgte varer
Sammenligne med tidligere solgte varer
 |
Ladeutstyr kraftpakke 2 000 ,- Solgt 13 år sedan På salg i 1 dag |
Motorsykler | ||
| Selger ladeutstyr pga av at jeg legger opp hobby på ubestemt tid. Maas Power 3-15V 40 A digitalt E-stationRevolextrix powerlab 8 oppgradert til v2,inkl Fuim3 interface for oppkobling mot pc.Spec.Powerlab8 For Battery types: Lithium Polymer (1s to 8s balanced, 1s to 2s unbalanced), Lithium Ion (1s to 8s balanced, 1s to 2s unbalanced), Lithium Manganese (1s to 8s balanced, 1s to 2s unbalanced), A123 (LiFePO4) (1s to 8s balanced, 1s to 10s unbalanced), NiCd (1s to 21s), NiMH (1s to 21s), 6v, 12v, 24v Lead Acid batteries (Flooded, Gel, AGM, SLA)Pack capacity: 20 mAh to 360AhInput voltage: 10-32VDC, reverse polarity protectedInput current: 1A to 60A, software limitedPower conversion: Synchronous DC/DC converter, supports multiple switcher frequencies of 31.25 kHz, 62.5 kHz, 125 kHz; user selectable by preset, 85% to 93% efficiency depending on output currentOutput battery charge current: Adjustable range 10mA to 40A, limited by 60A input current*Output battery discharge current: Internal discharge 10mA to 10A, 100W max Regenerative discharge 10mA to 40A, 1344W max**Continuous max output power: 612W @ +12VDC input, 1344W @ +26.35VDCCell balancing: Resolution 78uV (16 bit) for 1s-8s Li or A123 (LiFePO4) balanced chargingVoltage calibration: Cell voltage measurements are factory calibrated to a standard traceable to NIST; calibration is to +/- 6 mVCurrent calibration: Charge current is factory calibrated on a 4A standard; calibration is to +/- 1mAMeasurement accuracy: Voltage resolution: 78uV (16 bit) Voltage tolerance: +/- 6mV Charge current: +/- 1% Capacity added to pack: +/- 1% Percent capacity (“Fuel”): +/- 5% (with accurate fuel table defined for battery being charged)Serial data output: 19.2kbps, 8 bits, 1 start bit, 1 stop bit, no parityData integrity: Checksum, CRC checkingCooling fans: Twin, 13 CFM, 50mm diameterHeat sink: Internal 200W aluminum, thin finnedOutput battery connector: “Cellpro” compatible, JST PA series, 9 positionLCD: 2 line, 16 character, light grey/blue backlitSize: 5.82" x 6.55" x 3.57"Footnotes:* Please note, for safety reasons, available charger current may be limited for certain battery types and/or charging modes, e.g., non-balanced charge of Li** Please check bullet number 8 in the section titled “Major Features” (Features tab) for a detailed description of Regenerative DischargeSpec.E-stationOperating voltage DC 11~18 volts Idling current approx. 100mA Charge/discharge power max. 200/50W NiCd/MH 1~32 cells LiIo/LiPo/LiFe 1~12 series Pb 2~ 40V Charge current 0.1 to 9.9A Discharge current 0.1 to 9.9A No. of cycles 1 to 5 times Battery data memories up to 10 data OUTPUT~8 cells NiCd/MH (0.1~2.0A) External load R: 1 or 2 Ohms Motor Driver max. 20A load Weightg Dimensionx148x60 mmMaas powerV DC maks 40A utgang | ||||
|
BROOKLYN SMART CHARGER (PS3) Solgt 13 år sedan På salg i 448 dager |
|||
| NY VARE !!! This charging station can supply energy for one or two PS3 controllers. Each controller takes approximately three hours to load. The Smart Charger comes with a power supply that enables charging independently of the PlayStation®3. It simply needs to be connected to an electrical plug in order to charge the controller. A two coloured LED shows the current charging status. Delivered with a USB charging cable (three metres long). System: For PlayStation®3 SE BILDENE!Se flere gjenstander fra denne selgeren. | ||||
